• Search Again
  • Print
  • Send Via Email

Your selected equipment


Make
JOHN DEERE
Model
4045 (Tier2 PowerTech Series)
Engine
D / DT

Application
Recommendation
Capacity (gal)
Data Sheet
Sales Sheet
Engine (D / DT)
Premium
Maxtron DEO SAE 15W-40
(a, b, c, d, e, f, g, h)
PDS
Mainline
Superlube TMS SAE 15W-40
PDS
Coolant
Refer to Technical
(i)
Engine (D / DT)
Recommendation:
Premium Maxtron DEO SAE 15W-40
Mainline Superlube TMS SAE 15W-40
(a, b, c, d, e, f, g, h)
Coolant
Recommendation:
Ultra Premium Refer to Technical
(i)

General Notes

1.
Fuel sulphur content greater than 0.5% results in oil change intervals reduced by half

Lubricant / Capacity Notes

a.
Oil change interval can be extended using John Deere PLUS-50 or E4/E5 with specified John Deere filters, up to a maximum of 500 hours. Without specified filters change engine oil and filters at the normal service interval
b.
During engine run-in use John Deere Engine Break-in Oil. Alternatively engine oils to CE/E1/D4 may be used during the first 100 hours of engine use
c.
Multigrade engine oils are preferred. Synthetic engine oils are also suitable
d.
Alternative recommendations, -40°F to 122°F: Refer to Technical
e.
Alternative recommendations, -22°F to 104°F: Refer to Technical
f.
Alternative recommendations, -13°F to 122°F: Maxtron Enviro-Edge SAE 5W-40
g.
Alternative recommendations, -13°F to 104°F: Maxtron DEO SAE 10W-30 / Superlube TMS SAE 10W-30
h.
Alternative recommendations, -4°F to 122°F: Maxtron DEO SAE 15W-40 / Superlube TMS SAE 15W-40
i.
Cooling systems: Do not use automotive type coolants. John Deere products strongly recommended. Use Refer to Technical at a concentration of 40% mixture of concentrate with quality water and approved supplemental coolant additives for all year operation. Alternative specification; low silicate ethylene glycol based coolant for heavy duty diesel engines to Refer to TechnicalTM D5345 (pre-diluted) or Refer to TechnicalTM D4985 (concentrate) plus supplemental coolant additives

Oil Change Intervals

There is no Oil Change Interval data to display for this model